Lubrication - PRO-POINT 9081548 Mode D'emploi

V1.0
4. Pump the handle or pedal for several strokes or press the air valve
trigger to eliminate any air in the system.
5. Check the oil filler hole and if necessary, top off with more
hydraulic oil.
6. Restore the oil filler screw. Close the release valve by turning
clockwise.
7. Test the ram several times for proper operation before putting it
into use. Do not use the ram if it still does not appear to be working
properly. Have a qualified service technician service or repair the
hydraulic system.

LUBRICATION

Inspect and lubricate the tool when required. Only use light oil to
lubricate the tool. Other lubricants may not be suitable and could
damage the tool or cause a malfunction during use.
Clean and lubricate all moving parts.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other
lubricants are not suitable and will damage the tool or cause
a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's
grease packing and may damage the o-rings, causing the
tool to seize or malfunction.
1. All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a
generous amount of air tool oil in the air inlet and then run the tool
under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool's coupler
plug before each use and after every hour of continuous use. The
tool will not work properly without lubrication and parts will wear
prematurely.
Page 17
PNEUMATIC/HYDRAULIC SHOP PRESS
Assistance available at www.princessauto.com or 1-800-665-8685
9081548