Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9081548
2.
Place the heel blocks (#35) on the bed frame, then insert a
workpiece on the heel blocks.
•
Tapping the elastic cylinder pins out on the heel block's
corners can help hold them in position during the task
3.
Close the release valve (#13) on the pump by turning it clockwise.
4.
Pump the handle or pedal until the ram nears the workpiece.
5.
Align the workpiece and ram to ensure center-loading.
6.
Pump the handle or pedal to apply load onto the workpiece.
7.
Do not exceed the maximum piston stroke. If you see a red line
on the piston, retract the ram and adjust the bed to bring the
workpiece closer to the ram.
8.
Stop applying load to the workpiece when the task is complete.
9.
Slowly and carefully remove load from workpiece by turning the
release valve counterclockwise in small increments.
10. Once the ram has fully retracted, remove the workpiece from the
bed frame.
11. Close the release valve when you have finished for the day.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical replacement
parts when servicing.
3.
Only use accessories intended for use with this tool. Follow
instructions for changing accessories.
4.
Keep the tool handles or gripping surfaces clean and dry.
5.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
WARNING! Only qualified service personnel should repair
the tool. An improperly repaired tool may present a hazard
to the user and/or others.
Assistance available at www.princessauto.com or 1-800-665-8685
PNEUMATIC/HYDRAULIC SHOP PRESS
V1.0
Page 14
Publicité
Table des Matières
