System Error - ResMed S8 AUTOSET VANTAGE Manuel Utilisateur

Problem
Display error message:
Check tube!!
Key if done
Display error message:

SYSTEM ERROR

Call service!
Display error message:
High leak in
last session
Display error message:
HIGH LEAK!!!
Adjust Mask
Display error message:
Exxxx (where xxxx
defines an error)
The following message
is displayed on the
LCD after you try to
update settings using
the Data Card:
Card Error
Remove Card
Possible Cause
The air tubing is loose or
blocked.
Component failure.
You have experienced
excessively high leak levels
during the night.
You have experienced
excessively high leak levels for
more than 20 seconds.
Component failure.
The Data Card is not inserted
correctly.
The Data Card is only partly
inserted.
Solution
Check that the air tubing is
connected securely to your mask
and the air outlet on the front of
the S8 AutoSet Vantage.
When you have checked the air
tubing, press the Start/Stop key to
restart the device.
If this does not clear the message,
disconnect the power cord and
then reconnect it to restart the
device.
Return your S8 AutoSet Vantage
for servicing.
Check that your air tubing is
connected properly and that your
mask does not leak excessively.
Use the mask-fitting feature to
help you to fit your mask
properly.
If this message appears again,
contact your clinician.
Check that your air tubing is
connected properly and that your
mask does not leak excessively.
Use the mask-fitting feature to
help you to fit your mask
properly.
If this message appears again,
contact your clinician.
Return your S8 AutoSet Vantage
for servicing.
Ensure that the Data Card is
inserted with the arrow facing up
and pointing towards the device.
Ensure that the device is switched
on and in standby mode before
you insert the Data Card.
Ensure that the Data Card is
inserted into the slot on the Data
Card module as far as it will go.
T
ROUBLESHOOTING
37