Replacing The Fuse; Technical Specifications - Futurelight EVO-5 Mode D'emploi

The gobos may be cleaned with a soft brush. The interior of the fixture should be cleaned at least annually
using a vacuum-cleaner or an air-jet.
The dichroic colour-filters, the gobo-wheel and the internal lenses should be cleaned monthly.
To ensure a proper function of the gobo-wheel, we recommend lubrication in six month intervals. The
quantity of oil must not be excessive in order to avoid that oil runs out when the gobo-wheel rotates.
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamp".

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature t
Maximum housing temperature t
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
OSRAM HCI-T150/NDL PRO 6000h 150W G12
Topspot HIT 150W G-12 6000h 4200K nw
GE CMH 150/T G12 6000h 830 3000K
OMNILUX ODM 150W G-12 6000h 4200K
PHILIPS CDM-T 150W/830 G12 3000K
OSRAM HSD 150/70 G-12 7000K 2000h
FUTURELIGHT Easy-1 remote control
FUTURELIGHT EX-6/32 controller
FUTURELIGHT EX-8/32 controller
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-256/32 controller 16bit
FUTURELIGHT CP-528 controller 16bit
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 05.08.2005 ©
230 V AC, 50 Hz ~
200 W
5
3-pin XLR
via built-in microphone
360 x 300 x 290 mm
9.5 kg
: 45° C
a
(steady state): 60° C
B
0.5 m
0.5 m
T 4 A, 250 V
No. 91201794
No. 91201797
No. 91201800
No. 91201805
No. 91014045
No. 89101910
No. 51834010
No. 51834046
No. 51834047
No. 51834265
No. 51834286
No. 51834315
No. 51860102
No. 51860110
No. 51834001
28/53 51837558_V_1_2.DOC