Flex H 1105 VE Notice D'instruction D'origine page 20

Continuous operation with engaged switch
rocker:
`^rqflk>
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇ=çå=
ÉäÉÅíêáÅ=éçïÉê=íççä=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
Switch off the machine:
 To switch off the power tool, release the
switch rocker by pressing the rear end.
Overload protection
 If an extremely brief overload occurs, the
overload protection prevents damage to the
motor by automatically switching the device
off.
For further information on the manufacturer's
products go to www.flex-tools.com.
20
Operating instructions
 Do not place the grinding tool on the
workpiece until the power tool has reached
full speed.
 To obtain a good grinding result, move the
grinding tool evenly over the surface which is
to be ground down. Do not apply excessive
pressure.
 When the power tool is switched off, the
grinding tool continues running briefly.
 The H 1105 VE can also be used as
a support grinder. For this purpose remove
the handle and clamp the power tool in an
appropriate device (clamping diameter
40 mm).
Maintenance and care
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=
Cleaning
t^okfkd>
aç åçí=ìëÉ=ï~íÉê=çê=äáèìáÇ=ÇÉíÉêÖÉåíëK
 Regularly blow out the housing interior and
motor with dry compressed air.
 Clean the guard and pivoted edge segment
using dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
klqb
aìêáåÖ=íÜÉ=ï~êê~åíó=éÉêáçÇ=Çç=åçí=äççëÉå=
íÜÉ ëÅêÉïë=çå=íÜÉ=ãçíçê=ÜçìëáåÖK=kçåJ
Åçãéäá~åÅÉ=ïáää=ÇÉÉã=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=åìää=~åÇ=îçáÇK
H 1105 VE/H 1127 VE