Mounting The Hood - Zipper Maschinen ZI-RWM99 Mode D'emploi

16.3.2 Mounting the hood

5
4
ZIPPER MASCHINEN GmbH
ZI-RWM99
2. Loosen the four screws on the back of the unit (shown
in the picture on the left).
3. Position the bracket (4) and secure it with the
previously loosened screws.
4. Attach the safety switch (5) to the bracket (as shown in
the picture on the left).
5. Connect the cable to the safety switch.
6. Insert hood rod into the hollow shaft and fasten it with
the screws.
7. Place hood to the hood rod and fix it with screws.
8. Then put the cover onto the bracket and screw it tight
(as shown in the picture on the left).
9. Slide a cone onto the threaded shaft and loosely
tighten the quick-release nut.
10. The correctly mounted device now looks as shown in
the picture on the left.
www.Zipper-Maschinen.at
GETTING STARTED
26