Maximum Flow - Kripsol JCH 40 Manuel D'instructions

DETAIL OF INSIDE OF THE NOZZLE
11. USING AND SETTING THE HIDROJET
11.1 Once the HIDROJET, has been
installed, your swimming pool is ready
to become a place of fun and leisure,
thanks to the pleasant sensation of the
water or air current produced by the
unit.
From inside the swimming pool, start
the HIDROJET, by pressing the
pneumatic switch (no.1, fig. 9).
With the unit running you can obtain a
current of water alone, or mixed water

MAXIMUM FLOW

and air, by setting the front nozzles (see
fig. 9) as described below:
- Current of water only: The maximum
flow of water is obtained by turning the
internal nozzle (no.2, fig. 9) to the left.
The flow rate is reduced by turning it to
the right.
- Current of air and water: To control,
or eliminate, the flow of air, turn the
external nozzle (no.3, fig.9) to the left or
right.
MINIMUM FLOW
Fig. 9
22