Kripsol JCH 40 Manuel D'instructions page 18

7. FITTING THE FRONT
7.1 The complete front piece is supplied
assembled, comprising parts no.1 to
no.14 (see fig.3), with the exception of
the transparent pipe (no.2), which is
already fitted in the niche (see fig. 5).
To install complete front piece proceed
as follows:
- Connect pipe no.2, inserting it into the
pin of the pushbutton (no.1, fig. 3).
- Connect pipe no.15, inserting it into the
nozzle (no.6) on the front piece (see fig.5).
- Screw the four spacing screws (no.5)
into the niche (see fig. 5).
- House the complete front piece in the
niche, ensuring the that o-ring (no.14) is
Fig. 3
inserted in the orifice on the discharge
side (Ø 75 mm.), see fig. 5.
- Tighten the four screws (no.3) (see
fig. 5). Once they are tight the front is
fully in place.
Fig. 5
18