Kripsol JCH 40 Manuel D'instructions page 15

1. INSTALLATION
1.1 By choosing the up stream swimming
equipment model
manufactures by KRIPSOL, we think
you have made the best choice, and we
hope that you and yours enjoy your
swimming pool to the full.
The HIDROJET series comes with
various motor sizes, ranging from 2,5 HP
to 5,5 HP, which means the installation
can easily be adapted to any type of
swimming pool.
The electropump should be fitted as
close as possible to the pool so as to
maximize its performance by avoiding
frictional losses. The original diameters
of the PVC fittings supplied with the unit
should always be observer.
We recommend that you do not install
the electropump more that 15 m. from
the pool.
The KARPA series pump included with
the unit is not self-priming so must be
installed below the water level. The
prefabricated housing or hut for the unit
must be well ventilated, using fans if
necessary, so as to ensure proper
cooling of the pump and to avoid
condensation.
This will ensure the correct operation of
the HIDROJET.
OK
ENGLISH
HIDROJET,
NO NO
Fig. 1
15
2. FIXING THE NICHE
2.1 When installing the niche you
should take into account the fact that it
must be fitted in the position described
below:
The Ø 75mm. discharge mouth and the
Ø 90mm. suction mouth must be fitted
vertically, such that the discharge side
(Ø 75mm) is uppermost and the inlet
side (Ø 90mm) faces downwards (see
fig. 1).
You should also ensure that the
distance between the surface of the
water and the centre of the discharge
mouth is approximately 30 cm. (see
fig.1).
These instructions must be followed
to ensure the correct installation of
the unit and its good functioning.
DISCHARGE
SUCTION
WATER LEVEL