Kripsol JCH 40 Manuel D'instructions page 19

8. PVC KITS FOR JC40/JC45
8.1 Installation of PVC kit for models
JCH/JCL40 and JCH/JCL45:
Models JCH/JCL40 and JCH/JCL45,
include a PVC kit for the installation of
the suction line (Ø75 mm.) and
discharge line (Ø63 mm.) (see table
below).
Installation of the discharge line:
- Glue the 75x63 mm. reducing bush
(no.1, fig. 6) to the discharge mouth of
the niche (see fig. 6).
- Glue a Ø 63mm. pipe (*) in the reducing
bush (no.1, fig. 6).
- Glue the Ø 63mm. valve (no.2, fig. 6)
to the Ø 63mm. pipe (*).
- Glue a Ø 63mm. pipe (*) to the Ø63mm.
pipe (no.2, fig. 6).
- Glue the Ø 63mm. elbow (no.3, fig. 6)
to the Ø 63mm. pipe (*).
- Glue a Ø 63mm. pipe (*) to the elbow
(no.3, fig.6).
- Glue a 90/75/63 mm. conical reducer
(no.4, fig. 6) to the Ø 63mm. pipe (*)
and the Ø 90mm. connector on the
pump.
A
Installation of the suction line:
- Glue the 90x75 mm. reducing bush
(no.6, fig. 6) in the suction mouth of the
niche (see fig. 6).
- Using a Ø 75mm. pipe (*), glue a
Ø 75mm. elbow (no.5, fig. 6) on to the
reducing bush (no.6, fig. 6).
- Using a Ø 75mm. pipe (*) join the
other Ø 75mm. elbow (no.5, fig. 6) to
the elbow already glued (see fig. 6).
- Glue the Ø 75mm. valve (no.7, fig. 6)
to the elbow (no.5, fig. 6) using a
Ø 75mm. pipe (*) to join them.
- Glue a Ø 75mm. pipe (*) to the valve
(no.7, fig. 6).
- Glue a 90x75 mm. reducing bush (no.6,
fig. 6) to the Ø 75mm. pipe (*) and the
Ø 90mm. connector on the pump.
(*) PVC pipes not included in the kit.
PVC KIT FOR JCH/JCL40 AND JCH/JCL45
No.
1
2
3
4
5
6
7
B
Fig. 6
19
DESCRIPTION
75x63 mm. Reducing Bush
Ø 63 mm. Ball Valve
Ø 63 mm. 90º Elbow
90x75x63mm. Conical Reducer
90º Ø 75 mm. Elbow
90x75 mm. Reducing Bush
Ø 75 mm. Ball Valve
MODEL
JCH / JCL40 165
JCH / JCL45 165
C
QTY.
1
1
1
1
2
2
1
A B C
1005 700
1005 700