PROCESS
This menu allows you to choose the welding process: TIG or MMA (SMAW)
SETTINGS
This menu allows you to set:
The display mode gives access to more or less welding parameters and configurations.
- Easy: Display and reduced functionality (supported process: MMA, TIG DC or AC Standard and Spot).
- Expert: Full display and all processes are supported.
The name of the device and the possibility of customizing it.
Supported languages: FR, UK.....
The Units of Measurement: International (SI) or Imperial (USA).
The time and its format.
Screen contrast
The cooling unit (AUTO / ON / OFF) and the PURGE function of the cooling unit:
- AUTO: activation during welding and deactivation of the cooling unit 10 minutes after the end of welding.
- ON: the cooling unit is permanently controlled.
- OFF: the group is disabled.
- PURGE: function dedicated to purging the cooling unit or filling beams, the protections are then inhibited.
Product Reset (Partial / Total) :
- Partial (default value of the welding cycle).
- Total (factory configuration).
CALIBRATION
This mode is dedicated to the calibration of welding accessories such as torch, cable + electrode holder and cable + earth clamp. The calibration is
designed to compensate variables such as the length of the accessories in order to adjust the measurement of the voltage and improves the calcu-
lation of the energy. The procedure once launched is explained with an animation on the screen.
PORTABILITY
This feature allows you to save the welding configuration of the machine.
It also allows you to load a recovered configuration on another machine and inject it into another.
42
TITANIUM 400 AC/DC
EN