Télécharger Imprimer la page

GYS TITANIUM 400 AC/DC Mode D'emploi page 38

Masquer les pouces Voir aussi pour TITANIUM 400 AC/DC:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Non-pulsed duration
Post-gas
Duration between 2
points
Welding in E.TIG mode
This mode allows constant power welding by measuring arc length variations in real time to ensure constant bead width and penetration. In case the
assembly requires the welding power to be controlled, the E.TIG mode can be used as it is designed to ensure that the welding power remains the
same regardless of the position of the torch.
Standard (constant current)
2 mm
D
JOB MEMORIZATIONS AND REMINDERS
The current settings are automatically saved and loaded at start up.
In addition to the current settings, it is possible to save and recall so-called «JOB» configurations.
There are 100 JOBS per welding process, the memorization concerns:
- The main parameter,
- The secondary parameter (MMA, TIG),
- Subprocesses and button modes.
JOB MODE
This JOB mode allows you to create, save, recall and delete JOBs.
QUICK LOAD – Reminder of the JOBs to the trigger out of welding.
The Quick Load is a JOB recall mode (20 max) excluding welding and possible only in TIG process.
From a Quickload list of previously created JOBs, JOB reminders are made by short pull of the trigger. All trigger modes (2T/4T/4T/4Tlog) and welding
modes (SPOT/STD/PLS) are supported.
JOB 1 power surge
JOB 1
>0.5s
<0.5s
38
TITANIUM 400 AC/DC
, 0 - 60 sec.
0 - 60 sec.
0.1 - 20 sec.
5 mm
D
JOB 2 power surge
JOB 2
JOB 3
<0.5s
>0.5s
Smooth current phase manual or of a defined duration
Duration for which gas is released after the arc has stopped. It protects the weld pool
and the electrode against oxidisation when the metal is cooling down.
Time between the end of a point (excluding PostGaz) and the recovery of a new point
(including PreGas).
10 mm
D
D
When the mode is activated, JOB N°1 in the list is loaded and dis-
played.
The recall of the JOBs in the sequence is in loop: when the last JOB
in the list is reached, the next one will be JOB N°1.
Welding is activated by pressing and holding the buttons on the
torch.
E-TIG (constant power)
5 mm
2 mm
D
EN
10 mm
D

Publicité

loading