EKOM DK50-10 Manuel De L'utilisateur page 25

DK50-10
The cabinet for the DK50-10S/M 10 bar model compressor is equipped with a cooling
fan and a switch. The cabinet must be connected using the provided cord with connector
to the matching connector on the compressor's electrical panel. (Fig. 4)
Ensure the electrical cable does not touch hot compressor components. Risk of
electric shock!
If any electrical cord or air hose is damaged it must be replaced immediately.
Connecting a compressor not installed in a cabinet
 Insert the mains plug into a rated mains socket.
 The compressor is ready for operation.
Connecting a compressor installed in a cabinet
Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors.
Connect the DK50-10S/M 8-10bar cabinet
provided power cord with connector (1) into an outlet. (Fig. 8)
Disconnect the cabinet electrically from the compressor by pulling the connector (1) from the
outlet while the latch is released.
Fig. 8
11/2019
electrically to the compressor by inserting the
1
2
- 21 - NP-DK50-10-9_11-2019-MD