Assembly & Installation - Power Fist 8843633 Mode D'emploi

8843633
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Air Scraper
IDENTIFICATION KEY
A Cap Head Screw (2)
B Air Scraper
C Lever Trigger
D Air Connector with Air Flow Control
E Straight Blade
F Angle Blade
G Bent Blade
H L-Shaped Blade
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with
your tool.
1. Wrap the external threads of the coupler plug with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
8
Air Scraper Tool Kit
• Blades (4) • Hex Wrench
For technical questions call 1-800-665-8685
V1.0