Chauvet DJ GigBAR MOVE+ILS Mode D'emploi page 31

GigBAR RF Remote Control
The GigBAR MOVE + ILS can be operated with the GigBAR RF Remote. To enable RF wireless control,
follow the instructions below.
GigBAR RF Remote Operation
36
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> until RF is selected.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select COMMON (to connect a
GigBAR MOVE + ILS to any RF remote) or BIND (to pair an RF remote
to a specific GigBAR MOVE + ILS fixture).
7. Press <ENTER>.
Black Out
To black out the lasers with the RF remote:
• Press <BLACK OUT> on the RF remote.
This will turn off all the lasers until the button is pressed again.
NOTE: The RF remote will not respond to any inputs when Black Out is
activated. If the product does not respond when a button is pressed, try
pressing <BLACK OUT>. Black Out may have been activated.
Strobe
To activate strobe in manual mode using the RF remote:
1. Press <STROBE> on the RF remote.
2. Press <+> or <–> to adjust the strobe.
Dimmer
To adjust the dimmer using the RF remote:
1. Press <DIMMER> on the RF remote.
2. Press <+> or <–> to adjust the brightness.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode with the RF remote:
1. Press <AUTO> on the RF remote.
2. Press <+> or <–> to choose between the different auto programs.
Speed
To adjust the auto program/spot speed with the RF remote:
1. Press <SPD> on the RF remote.
2. Press <+> or <–> to increase or decrease the program speed.
Sound-Active Mode
To turn on Sound-Active mode with the RF remote:
1. Press and hold <SOUND> on the RF remote.
2. Press <+> or <–> to select a sound-active program.
To adjust the sound sensitivity:
1. Press <SENS> on the RF remote.
2. Press <+> or <–> to increase or decrease the sensitivity.
Freeze
To pause an auto program using the RF remote:
1. Press <FREEZE> on the RF remote.
GigBAR MOVE + ILS User Manual Rev. 7
Operation