Chauvet DJ GigBAR MOVE+ILS Mode D'emploi page 21

Pan Reverse
To manually set the orientation of the pan on the GigBAR MOVE + ILS, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Pan1 Reverse (for Spot 1) or Pan2 Reverse (for Spot 2).
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal pan motion) or ON (reversed pan motion).
7. Press <ENTER>.
Tilt Reverse
To manually set the orientation of the tilt on the GigBAR MOVE + ILS, follow the instructions below:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt1 Reverse (for Spot 1) or Tilt2 Reverse (for Spot 2).
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal tilt motion) or ON (reversed tilt motion).
7. Press <ENTER>.
Pan Range
To set the maximum angle of the pan on the GigBAR MOVE + ILS, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Pan Range.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to set the pan angle from 180 (180°), 360 (360°), or up to 540 (540°).
7. Press <ENTER>.
Tilt Range
To set the maximum angle of the tilt on the GigBAR MOVE + ILS, follow the instructions below:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt Range.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to set the tilt angle from 90 (90°), 180 (180°), or up to 270 (270°).
7. Press <ENTER>.
Factory Reset
To reset specific functions or the entire product, do the following:
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SETUP is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select RESET.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select YES (to reset the product configuration) or NO (to cancel).
7. Press <ENTER>.
26 GigBAR MOVE + ILS User Manual Rev. 7
Operation