Chauvet DJ GigBAR MOVE+ILS Mode D'emploi page 15

Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
Orientation
The GigBAR MOVE + ILS must be mounted in a position that includes planning for safe laser usage. In
addition, make sure adequate ventilation is provided around the product.
Rigging
• Before deciding on a location for the product, always make sure there is easy access to the product
for maintenance and programming.
• Make sure that the structure or surface onto which you are mounting the product can support the
product's weight (see the
• When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, such as an elevated platform or a truss.
• When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
• The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Mounting Diagram
Proper Usage
This product is for overhead mounting only. For safety purposes, Chauvet recommends mounting lighting
effect products on steady elevated platforms or sturdy overhead supports using suitable hanging clamps.
In all cases, use safety cables. Obtain appropriate mounting hardware from your lighting vendor.
International laser safety regulations require that laser products must be operated in the fashion
illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and
the lowest laser light. Additionally, 3 meters of horizontal separation is required between laser light
and audience or other public spaces.
CAUTION! Use of controls, adjustments, or procedures other than THOSE specified IN
THIS USER MANUAL may result in hazardous radiation exposure.
20
Technical Specifications)
Safety cable
(such as CH-05
from Chauvet)
Tripod mounting
insertion point
3 meters
GigBAR MOVE + ILS User Manual Rev. 7
Setup
Safety Notes.