Ce Declaration Of Conformity - Amann Girrbach ceramill motion 2 Mode D'emploi

M A C H I N E S P E C I F I C A T I O N S
4.1.2 Intended Use
The Ceramill Motion 2 is a PC-controlled milling
E N
and grinding machine for the fabrication of den-
tures by means of:
_ Dry processing of blanks made of
▪ pre-sintered zirconium oxide
▪ unsintered non-precious metals (NPMs)
▪ wax
▪ plastics
_ Wet processing of blanks made of
▪ sintered glass ceramic
▪ plastics
Using blanks and tools not approved by
AmannGirrbach can damage the machine and
make the product unusable. For such cases,
AmannGirrbach shall assume no liability whatso-
ever.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
A compressed-air connection is required
for operation of the Ceramill Motion 2 (see
page 62).
Dry processing is permitted only in conjunction
with an appropriate extraction system (for techni-
cal requirements, please refer to page 63). We
recommend using Ceramill Airstream.
Wet milling and grinding is permitted only in con-
junction with Ceramill Coolstream (accessory).
50
4.1.3

CE Declaration of Conformity

In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
The product's Declaration of Conformity can be
www.amanngirrbach.com
viewed under .