CASO DESIGN Cafe Crema Touch Mode D'emploi Original page 74

Press and the button
flashes. Remove the water tank. The LED
is emptied and then switches itself off. Pull the mains plug. Store the device at a dry
location. If you want to put the device back into operation, then proceed as described
under "Before first use".
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Attention
Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
17.1 Causes and rectification of faults
Problem/display
Buttons do not react
immediately to pressing
them or react badly
The LED flashes
The LED flashes
The LED lights
up constantly.
The LED flashes
LED constantly
illuminated
at the same time until the device beeps twice. The LED
Possible cause
The buttons are dirty.
The water tank is not correctly
inserted.
Not enough water in the water
tank.
Not enough beans in the bean
container.
Coffee grounds container is full.
The coffee grounds container is
not correctly inserted.
Brewing unit is not correctly
inserted. Place the brewing unit
correctly.
now flashes constantly. The device
Possible solution
Wipe the panel with a damp
cloth and then dry it off.
Put your finger completely
on the key.
Place the water tank
correctly.
Refill water.
Refill the beans.
Empty the container.
Place the container
correctly.
74