CASO DESIGN Cafe Crema Touch Mode D'emploi Original page 61

6. We recommend a manual cleaning process: To do this, keep the
button pressed at the same time until the device beeps twice.
and light up. Confirm with
7. Then flashes
cleaning process. This process takes a few minutes (approx. 15 minutes), during which
hot water is flushed through all pipes with short interruptions until the water tank is
empty. Then
up.
8. Perform the following steps as soon as possible, otherwise the device could switch off:
Empty the large container. Remove the water tank and fill it again up to the max mark.
As soon as you put the water tank back in, the cleaning process continues
automatically. Now there are 2 rinsing processes in which hot water are rinsed through.
9. After the last cleaning process, the device switches off.
10. Switch the device on again. The automatic rinsing process is arranged. Then connect
the hose and the milk tank to the milk spout to clean the milk system. Fill the milk tank
with water up to the max mark and use the milk foam function twice.
11. Then empty the remaining water in the milk tank. If desired, add milk to the milk tank.
12. Now you can completely reassemble and then use the device.
in the display and indicates that the device is performing the
flashes in the display and the
.
button and
button and
button light
61