Publicité
Les langues disponibles
Les langues disponibles
Fill the water tank up to the Max mark. Enter descaling agent into the water tank. Insert the
water tank into the appliance. Plug in the mains plug. Place a large collecting vessel in
such a way that it is positioned under the spout as water escapes from it. (If necessary
remove the drip tray if the vessel would not otherwise fit under the spout.)
Press and hold the
button and the
button at the same time until the device
beeps twice.
and
flash in the display. Confirm descaling with
.
The
symbol flashes in the display and indicates that the device is performing the
descaling and cleaning process. This process takes a few minutes (approx. 15 minutes),
during which hot water is flushed through with short interruptions until the water tank is
empty.
WARNING
► Be careful as hot water may spurt out of the device / vessel, risk of burning or scalding.
When the first step of the descaling process has been performed, then
flashes in
the display and the
button and the
button light up.
Perform the following steps as soon as possible, otherwise the device could switch off:
Empty the large container. Remove the water tank. Remove all the remains of the
descaling agent from the water tank and thoroughly rinse it.
Fill the watertank again up to the max mark. As soon as you put the water tank back in, the
cleaning process continues automatically. Now there are 2 rinsing processes in which hot
water are rinsed through. After the last cleaning process, the device switches off.
Empty the collecting vessel and thoughly rinse the water tank once more.
The device can then be operated as usual.
Please note
► Never interrupt the descaling process.
► The guarantee excludes devices which have stopped working or do not work properly
due to lack of descaling.
16.8 Emptying the appliance
A device that is not used for a long time, stored or sent to our customer service for repair
must be completely emptied.
73
Publicité
