Publicité
Les langues disponibles
Les langues disponibles
6
Push the crown back in to the normal position to set the time by receiving a radio signal.
The preliminary position adjustment
mode is automatically terminated and
the watch starts moving.
0 1
2
54
8B92̲E̲42-66.indd 54-55
Conduct manual reception.
→ HOW TO CONDUCT MANUAL RECEPTION
* Because the crown has been pulled out to
the second click (procedure 1), the watch
gains or loses time. Set the watch to the
correct time.
When the watch is used in conditions in
which the watch may be unable to receive a
radio signal, set the time and date manually.
The operation has been completed
when the time and date is correctly
set.
IMPROPER FUNCTION
When an abnormal display appears, follow the procedures below to reset the
built-in IC. The watch will resume its normal operation.
When pulling the crown to the
1
second click, the second hand stops
at the 0-second position.
0-second position
0 1
2
* The date and stopwatch hands also stop.
Resetting the IC will initialize the watch.
Before starting to use the watch, it will be
necessary to set the time and adjust the
STOPWATCH hands to the "0" position.
Press and hold Button C and
2
Button D simultaneously for 3
seconds, and then release them.
In five seconds after releasing the buttons, the
second hand makes a full rotation and stops at
the 0-second position. Then the hands of the hour
and minute will start to move toward the 0-second
position.
C
D
Push the crown back into the normal
3
position and check if the small
second hand moves as normal.
55
2016/04/27 15:55
Publicité
