Seiko 8B92 Manuel D'instructions page 21

HOW TO CONDUCT MANUAL RECEPTION
(RECEIVING A RADIO SIGNAL MANUALLY)
Placing the
Check that the
1 2
stopwatch is
watch
reset and the
time zone is set.
When receiving a radio
signal, place the watch
* If the stopwatch is
where it can easily
not reset or the time
zone is set to a region
receive a signal.
other than receivable
area, the watch will
be unable to receive a
radio signal.
→
HOW TO USE THE
STOPWATCH
→
HOW TO SELECT THE
TIME ZONE.
→  R ECEPTION ENVIRONMENT
40
8B92̲E̲38̲41.indd 40-41
Keep pressing Button B until
3
the second hand has finished
its movement to the 0-second
position (for 3 seconds).
When the second hand has moved to
the 0-second position, the watch will
start to receive a radio signal.
* If the second hand does not stop at the
0-second position, manual reception
cannot be conducted. Re-attempt the
operation from procedure 2.
Place the watch down and leave it
4
untouched for several minutes.
* If the watch is moved or any operation is conducted
during a radio signal reception attempt, the watch
will be unable to receive a radio signal.
It takes 12 minutes at the longest according
to the receiving state of a radio signal.
When the second hand starts moving in 1-second increments,
the reception is completed.
Reception level is updated by moving the second hand
every one minute.
Display During Reception
Receiving Level Receiving Level
High(H): Low (L):
50-second 40-second
position position
* It is difficult to receive the signals in some receiving conditions. → RECEPTION ENVIRONMENT
* This watch is unable to receive a radio signal outside a reception range. → RADIO SIGNAL
RECEPTION RANGE
* If the second hand points to "L," the watch may not be able to receive a radio signal.
When radio signal
5
reception is completed, the
second hand starts moving
in 1-second increments.
Check whether the receiving a
radio signal has been successful.
→HOW TO CHECK THE RECEPTION STATUS
If the Reception has failed
Receiving Level
Reception Failed(N):
20-second
position
After five seconds, the watch
will resume displaying the time.
41
2016/04/28 15:41