Fuse Replacement - afx light HYBRID180 Manuel D'utilisation

• In the event of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
• The light source of this device is not replaceable. If it is defective, the entire unit must be discard-
ed.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
FEATURES
• Anti-reflection lenses 136mm
• 17/15/19 DMX channels USITT DMX-512
• BEAM 2.5° to 14°
• SPOT 8° to 36°
• 1 rotating gobo wheel with 6 gobos + Open
• 1 static gobo wheel with 16 gobos + Open
• 1 colour wheel with 10 colours + Open
• DMX, master-slave, sound activated or auto operation (8 built-in programs)
• Motorized focus from 2-20m
• Linear motorized zoom
• Automatic Pan/Tilt position correction
• Scan position memory
• 10x/sec shutter/strobe with speed control
• 0-100% linear LED shutter
• 3-facet prism with variable speed & direction
• 2.4" LCD touch display with 5 buttons
• Reversible display for upside down applications
• Vector mode with blackout MIB function
• Fan cooled

FUSE REPLACEMENT

Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus-
tomer support for further instructions. Continuing to use the unit may cause serious damage.
FIXTURE LINKING (FIG4)
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller
or to run synchronized shows on two or more fixtures set to a master/slave operating mode. The
combined number of channels required by all fixtures on a serial data link determines the number
EN 8
© Copyright LOTRONIC 2022