Fuse Replacement; Mounting Points - afx light SPIN12-FX Manuel D'utilisation

• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• If the lenses are visibly damaged by scratches or cracks, stop using the unit immediately and
replace the damaged lenses.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.

FUSE REPLACEMENT

• Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
• With a Phillips head screwdriver wedge the fuse holder out of its housing.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse (F3A).
• Insert the fuse holder back in its place and reconnect power.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.

MOUNTING POINTS:

Overhead mounting requires extensive experience, including amongst others, calculating working
load limits, a fine knowledge of the installation material being used, and periodic safety inspection
of all installation material and the fixture. If you lack these qualifications, do not attempt the ins-
tallation yourself. Improper installation can result in injuries.
Be sure to complete all rigging and installation procedures before connecting the mains power cord
to an appropriate wall outlet.
CLAMP MOUNTING :
The LED moving head provides a unique mounting bracket assembly that integrates the bottom
of the base: the included 'omega bracket' and the safety cable rigging point in one unit (see the
illustration below). When mounting this fixture on a truss, be sure to secure an appropriately rated
clamp to the included omega bracket using a M10 screw fitted through the center hole of the 'ome-
ga bracket'. As an added safety measure, attach at least one properly rated safety cable to the
fixture using one of the safety cable rigging points integrated in the base assembly.
www.afx-light.com
3 EN