Eden Royal Well Burford 86 Manuel D'instructions page 73

Hints and Tips Handbook
Section 8.1.1
If you have hung your doors and they are not fitting correctly within the
aperture, this section will take you through the steps needed to line up the
doors correctly. If the aperture of the doorway is not square and plumb
this will hamper the way the sliders (114) work and lead to various issues.
These steps will work on all models. We recommend that you remove the
doors before attempting this. 1, 2 and 3 of the following steps must be
carried out simultaneously as they are dependant on each other.
1
1. Make sure that the front base sections (18) are level.
2. Make sure that the door posts (16) are not bowed but straight all the
way up by placing a level or straight edge to check. Another way to check
this is to measure from the centre of the bolt channel on both door posts,
checking they are the same distance apart all the way down. (I.e. parallel)
12
3
2
1
Eden Greenhouses Customer Helpline +44 (0)1242 676625
3. Make sure that the lintel (20, 21) is level.
4. Once the previous steps have been carried out and the door aperture is
now level and square, we can now reattach the door(s) as detailed in
section 8.1 of this Hints and Tips Handbook as well as the instruction
manual provided with your greenhouse. Leave the 3 nuts and bolts (50, 51),
which connect the front base section (18) to the base slide bracket (97),
loose.
5
05. With the doors now hung and the 3 nuts and bolts (50, 51) which
connect the front base section (18) to the base slide bracket (97) loose, step
inside the greenhouse and shut the door(s) hard. This will allow the bottom
sliders to find their own position, (parallel to the lintel). Once happy with
the doors, tighten the 3 nuts and bolts (50, 51) to secure.
4
5