Eden Royal Well Burford 86 Manuel D'instructions page 62

Dear Customer,
Congratulations on purchasing your new Eden Zero threshold
Before you start, please read the instruction booklet supplied with your greenhouse thoroughly. This Hints and Tips Handbook is aimed to be a companion to
make the erection of your new Eden Zero threshold
The components for your greenhouse are in numbered bundles corresponding to the sections in the instruction manual and this handbook. There may be
more than 1 bundle per section. Build one section at a time from the start so as to not cause any confusion.
This handbook is aimed at the new Eden Zero threshold
greenhouse but can be interpreted for any model.)
TM
new Eden Zero threshold
The range of greenhouses are constructed using bolt channels. Take note of where you will
need to slide extra bolts into the channels for fixing horizontal bars, bracing or roof vent sills as per the example picture to
the right.
The square headed bolts and nuts (50, 51) are made from an aluminium alloy which can sheer if over tightened. To
prevent the inconvenience of having to dismantle a section to replace a sheered bolt, please ensure that you only tighten
them a little more than finger tight as this is all that is required.
NOTE: THIS IS FOR DIMENSION MEASUREMENTS ONLY
0
TM
greenhouse.
TM
greenhouse as smooth as possible when read in conjunction with the supplied instructions.
TM
range as a whole not one specific model or size. (Pictures may not correspond with your
This section shows the measurements required to situate the ground anchors
ONLY, if you have chosen to site the greenhouse on earth. Make sure you have
the correct size for your specific greenhouse.
If you have chosen to prepare a base of some sort for your greenhouse to be sited
on other than earth, please refer to the dimensions on the front cover of your
instruction manual or our Eden Zero threshold
MINIMUM dimensions of base required for your model and size.
Eden Greenhouses Customer Helpline +44 (0)1242 676625
Hints and Tips Handbook
74
Section 0
TM
range brochure for the
1