Eden Royal Well Burford 86 Manuel D'instructions page 64

Section 2
This section shows you how to assemble the front gable of your greenhouse.
TM
The Eden Zero threshold range has four different sized bays when it comes to
the front gable (illustrated by arrows, right and below) to make the assembly
easy and to minimise adjustments needed when it comes to glazing.
The table below will show the measurements needed for the bays.
(Measurements are taken from the centre of the bolt channel to the next.)
Model 386mm
Birdlip 2 bays
Burford
Blockley
Bourton
2
(I)
(I)
(I)
(I)
463mm 618mm
Door Aperture
2 Bays/Door
2 Bays Door Aperture
4 Bays Door Aperture
These tips are to make the assembly simple
(I)
when it comes to section 4 ASSEMBLE.
(I)
An extra square headed bolt (50) and nut
(51) should be located in the return of
(I)
corner posts (5) and gable bars (5, 13) at
each end as shown left and above (I)
(I) 100mm from the ends for use later.
When constructing the gables the horizontal
brace (11) should be level with the top of
Another way to make sure there will be
minimal adjustment needed when you come
to assemble the sections together is to
loosely fit the gusset plate (9) to the corner
post (5) and the gable bar (13).
Then measure and adjust the gusset plate
(9) into the top of the corner post (5) 65mm,
and 70mm up into the gable bar (13) as
Eden Greenhouses Customer Helpline +44 (0)1242 676625
2
(I)
1236mm
the corner post (5)
as shown right (A).
shown right (B).
Hints and Tips Handbook
(I)
(I)
(I)
(I)
5/13
(A)
9
11
(I)
(I)
(I)
(Outside)
(B)
5
3