Eden Royal Well Burford 86 Manuel D'instructions page 72

Section 8.1
This section shows you how to fit the doors to your greenhouse.
TM
The Eden Zero threshold range has different sizes when it comes to the
doors but the method of assembly is the same. Below, find step by step
instructions. This method can be used on all doors both left and right (note
picture shown right is a right hand door).
Start by removing the door stop (52) from the top of the door as shown in
boxes 1 and 2 in your instruction manual. This will be reattached after the
door is fitted in place.
The remaining outer slider (114 B) needs to be secured to the lintel (20, 21).
The best way to do this is by removing the lintel (20, 21) momentarily to fit the
outer slider (114 B). Then secure with M4 nut, bolt and a star washer (102, 103
and 118) as shown in box 3, 5 in your instruction manual.
If you have removed the lintel (20, 21) to fit the outer slider (114 B) please
reattach. Once lintel is back in position we can now fit the door.
As shown in box 4 slide the inner slider (114 A) (attached to the top of the
door) into the outer slider (114 B) (attached to the lintel) and slide the door all
the way into the closed position as shown in boxes 5 or 7.
With the door in the closed position, slide the bottom slide assembly
underneath the top lip of the front integral base (18) as shown in boxes 6 or 8.
Line up the holes on the front base slide bracket (97) with the holes on the
front integral base (18) as shown in boxes 7 or 9 and 12.
Then secure the two with three square headed bolts and nuts (50, 51) as
shown in boxes 8 or 10 and 13.
The remaining boxes in this section show you how to make adjustments.
If the door is not straight within the aperture, it usually means that the front
base slide bracket (97) is not level with the lintel (20, 21). To make this
adjustment, take a step back and look to see whether they are level by
checking as shown above right by (A). This can be adjusted by moving the
front base slide bracket (97) as shown in boxes 9 or 11 and 14.
Eden Greenhouses Customer Helpline +44 (0)1242 676625
8.1
(A)
Further adjustments can be made by loosening off the square headed bolts
and nuts (50, 51) as shown in boxes 10 or 15 and 16. This will lower the side
of the door which will make the door swing the opposite way. NOTE THIS
ADJUSTMENT CAN BE ONLY MADE TO ONE SIDE OF THE DOOR AT A TIME.
Then reattach the door stop (52) we removed earlier as shown in boxes 11,
12 or 17, 18. Then secure the panes in the door using the "W" spring wire
clips provided.
If you have a double door model, follow these instructions using the
pictures in your instruction manual as a guide for the remaining door.
If you have followed these instructions but the doors don't line up
correctly please refer to the next trouble shooting page.
The louvre section shows the greenhouse bays that are able to
accommodate a louvre if you wish to fit one.
Hints and Tips Handbook
(A)
11