Eden Royal Well Burford 86 Manuel D'instructions page 70

Section 7. #
This section shows you how to assemble the slide assembly to the doors for
your greenhouse (illustrated right).
TM
The Eden Zero threshold range has only two different widths when it
comes to the door slide assembly which are 300mm (Birdlip) and 600mm
(Burford, Blockley, and Bourton).
Below, find step by step instructions to construct the door slide assembly.
This method can be used on all doors both left and right (note picture
shown right is a right hand door when viewed from outside).
Start by sliding the brush strip (109) into the bottom door assembly bracket
(95) and secure in place with the grub screws (104) at both ends as shown in
box 1 in your instruction manual.
As the pictures below show, remove the slider inner (114 A) from the outer
of the slider (114 B) by extending the slider to full extent then as shown in
the instruction manual, squeeze the lever. By doing this you will be able to
slide (114 A) out from (114 B).
Using the slider layout page in your
your instruction manual in section 7
(right) line up the slider inner (114 A)
top rail depending on which hand door you're constructing then secure with
M4 nut, bolt and a star washer (102, 103 and 118) as shown in box 2.
As shown in box 3 secure the slider inner (114 A) to the bottom door
assembly bracket (95) referring to the layout, depending on which hand
door you're constructing, with M4 nut, bolt and a star washer (102, 103 and
118).
Box 4 shows to secure the outer slider (114 B) to the front base assembly
bracket (97), referring to the layout depending on which hand door you're
constructing, with M4 nut, bolt and a star washer (102, 103 and 118).
in
shown
with the
Eden Greenhouses Customer Helpline +44 (0)1242 676625
7. #
31
As shown in boxes 5, 6, 7 and 8, slide the slider inner (114 A) with attached
bottom door assembly bracket (95) into the outer slider (114 B) with
attached front base assembly bracket (97) to create the complete bottom
slide assembly.
Then secure the complete bottom slide assembly to the bottom of the door
with 3 square headed bolts and nuts (50, 51) as shown in boxes 9 and 10.
If you have a double door model, follow these instructions using the
pictures in your instruction manual as a guide for the remaining door.
Hints and Tips Handbook
29
9