Hints and Tips Handbook
Section 5
This section shows you how to assemble the roof of your greenhouse.
TM
The Eden Zero threshold
range has only one size of bay when it comes to the
roof (illustrated by arrows, right). This is to make the assembly easy and to
minimise adjustments needed when it comes to glazing.
The table below will show the measurements needed for the bays.
(Measurements are taken from the centre of the bolt channel to the next.)
Model
Birdlip
Burford
Blockley
Bourton
The table (left) in Section 5 of your instructions shows how
2a 2b
1
many square headed bolts/nuts (50, 51) are required to be
pre loaded as shown below into the roof glazing bars (1,
x / x /
23). Model and size specific. Doing this before assembling
x / x /
the roof will save time when it comes to fitting the apex,
x / x /
eaves braces and vent transoms (40, 60, 41, and 27).
PRE LOAD
2a
PRE LOAD
2b
PRE LOAD
6
618mm
All
All
All
All
50, 51
1 / 23
50, 51
1 / 23
Eden Greenhouses Customer Helpline +44 (0)1242 676625
5
A time saving tip is to pre load the ridge bar (22) with square headed
bolts and nuts (50, 51) before placing into position as shown below left.
In section 3 the tip to place an extra square headed bolt and nut (50, 51)
into the side glazing bars (1) now comes into play as shown below right.
22
1,23
50, 51
1, 23
4
2
40
1