Eden Royal Well Burford 86 Manuel D'instructions page 63

Hints and Tips Handbook
Section 1
This section shows you how to assemble the rear gable of your greenhouse.
TM
The Eden Zero threshold range has only two different sized bays when it comes
to the rear gable (illustrated by arrows, right and below). This is to make the
assembly easy and to minimise adjustments needed when it comes to glazing.
The table below will show the measurements needed for the bays.
(Measurements are taken from the centre of the bolt channel to the next.)
Model 386mm
Birdlip
Burford
Blockley
Bourton
1
(I)
(I)
(I)
(I)
2
463mm 618mm
3 Bays
3 Bays
4 Bays
4 Bays 2 Inner bays
(I)
These tips are to make the assembly simple when
(I)
it comes to section 4 ASSEMBLE.
An extra square headed bolt (50) and nut (51)
should be located in the return of corner posts
(I)
(5) and gable bars (5, 13) at each end as shown
(I)
left and above with (I) 100mm from the ends for
When constructing the gables, the horizontal
brace (10) should be level with the top of the
corner post (5) as shown right (A).
Another way to make sure there will be minimal
adjustment needed when you come to assemble
the sections together is to loosely fit the gusset
plate (9) to the corner post (5) and the gable bar
Then measure and adjust the gusset plate (9) into
the top of the corner post (5) 65mm, and 70mm
up into the gable bar (13) as shown right (B).
Eden Greenhouses Customer Helpline +44 (0)1242 676625
1
(I)
(I)
later use.
10
(13).
(I)
(I)
(I)
(I)
(Outside)
5/13
(A)
9
5
(I)
(I)
(B)