Eden Royal Well Burford 86 Manuel D'instructions page 69

Hints and Tips Handbook
Section 7
This section shows you how to assemble the doors for your greenhouse.
TM
The Eden Zero threshold range has different sizes when it comes to the
doors but the method of assembly is the same. Below, find step by step
instructions to construct a door. This method can be used on all doors both
left and right (note picture shown right is a right hand door when viewed
from outside).
Start by applying the glazing rubber (42) to the door stile (28, 65, and 66) as
shown in box 1 in your instruction manual.
Pre load each door stile (28, 65, and 66) with 8 square headed bolts (50) as
shown in box 2 in your instruction manual.
Check the door layout referring to the large picture in the top left of the
instruction manual. Then, with both door stiles (28, 65, and 66), attach the
door top rail (29) with a door stop (52) on the inside of the door, with 2 pre
loaded square headed bolts (50) and nut (51) as shown in box 3 and 4 in
your instruction manual.
Slide the top pane of glass up to the top door rail (29) referring to section 9
for correct size, as shown in box 5 in your instruction manual.
On the back of the centre door rail (30) there is a channel which the black
foam pad (112) needs to be slid into as shown in box 6.
Next attach the centre door rail with black foam pad (30, 112) using 2 pre
loaded square headed bolts (50) and nuts (51) as shown in box 7 in your
instruction manual. N.B. Make sure at this point the holes for the lock line
up.
Slide the next pane of glass up to the centre door rail (30) referring to
section 9 for correct size, as shown in box 8 in your instruction manual.
Attach the intermediate door rail (32) with the relevant door / lock keeper
(107, 108) with 2 pre loaded square headed bolts (50) and nuts (51) as
shown in box 9 in your instruction manual.
8
7
Slide the next pane of glass up to the intermediate door rail (32) referring to
section 9 for correct size, as shown in box 10 in your instruction manual.
Attach the bottom door rail (32) with a door stop (52) on the inside of the
door with 2 pre loaded square headed bolts (50) and nuts (51) as shown in
box 11 in your instruction manual.
As shown in box 12, 13 insert the push lock (111) then secure in position on
the centre door rail (30) with the brass nut.
Attach the door handle (48) to the small hole on the centre door rail (30) as
shown in box 14 in your instruction manual.
If you have a double door model, follow these instructions using the
pictures in your instruction manual as a guide for the remaining door.
Eden Greenhouses Customer Helpline +44 (0)1242 676625