Eden Royal Well Burford 86 Manuel D'instructions page 68

Section 6
This section shows you how to assemble the roof vents for your
greenhouse.
TM
The Eden Zero threshold range has only one style when it
comes to the vents as shown right.
The best way to assemble the vents is from the underside as
shown right.
Start by applying the glazing rubber (42) to the vent sides (25).
Then pre load 2x square headed bolts and nuts (50, 51) into the
holes provided at either end of the vent head, vent sill (24, 26).
Using the pre loaded bolt and nut slide the vent head (24) into
both bolt channels of the vent sides x2 (25) at the same time then
tighten (as shown in (A).
Follow the same instructions above for the vent sill (26) as shown
in (B).
Then screw the vent stay/handle (71) using screws supplied into
the holes provided in the vent sill (26) as shown in (C).
(A)
24
25
25
6
(B)
25
26
Eden Greenhouses Customer Helpline +44 (0)1242 676625
25
71
26
25
26
Hints and Tips Handbook
24
42
25
(B)
71
26
(C)
7