Aqua Medic Refill-System Mode D'emploi page 8

1. Delivery
1. Power supply AC/DC, Input 100 - 240 V AC 50/60 Hz, Output 12 V DC 2.0 A
2. Control unit
3. Infrared sensor N1
4. Sensor N2
5. Refill pump Input DC 3.5 - 12 V DC / 0.5 – 5.0 W H
6. Sensor N3
7. 2 m refill hose 8/12
2. Features
- Permanent monitoring of the water level in the aquarium with an infrared sensor incl. delay
circuit.
- Automatic refilling of evaporated aquarium water.
- Adjustable water level with overflow protection in the filter tank (safety shutdown in case of a
defective level sensor).
- Dry-running protection of the refill pump – optical and acoustic alarm.
- Easy installation and maintenance due to plug connections on all cables.
- 12 V low voltage
3. Installation
Important! Please turn on the power supply only when all of the cables and sensors are
connected, otherwise the control unit may be damaged. Unplug the power from the unit
in case plugs are to be pulled.
The Aqua Medic Refill System is designed as a refill unit for cabinet filter systems, only if the
aquarium has a minimum height of approx. 13 cm between the top of the aquarium and the water
level. Mounting of the sensors N1 and N2 is achieved with the bracket supplied.
Pict. 1: Control unit with connected sensors N1 – N3
D1 = Power
D2 = Alarm in case of low water level in the refill unit (+ beep)
D3 = Refilling is active
The power supply has an exchangeable plug for use in different countries. To remove the plug,
press the release button on the back of the power supply. The power supply is connected to the DC
12 V socket, the pump connects to the other socket on the unit.
8
= 220 cm Q = 350 l/h
max max