Flow Switch - Hayward AQUARITE FLO ADVANCED Guide De L'utilisateur

10.21
10.21 Open the cover of the
WiFi box.
Connection
 
Cover &
Connection

Flow switch

Page 11 of 12
10.2. WIFI INSTALLATION
10.22
10.22 Cut the flange.
12. FLOW SWITCH
 
&
USE ONLY GENUINE REPLACEMENT PARTS
AquaRite Flo Advanced
11.23
10.23 Disconnect the cables.
11. COVER
11.1
11.1 Cover: Connection of
automatic cover.
Input for mechanical security flow switch. It stops the electrolysis and dosing
pumps if there is no water flow.
It is possible to add an external flow switch to the system. Connect as shown in
the illustration and contact your installer to activate it. The titanium cell includes a
gas flow sensor, and you can combine the two for better control.
11.24
10.24 Pass the cable
through the cable gland
from the inside outwards.
10.25 Connect the cables again in
the WiFi box.
11.2
11.2 Reduction of chlorine
production (as a percentage), when
the pool cover is closed.
With the cover closed it is not
necessary for the system to run
at 100%. Use this parameter to
regulate the optimal amount of
chlorine produced.
11.25
Rev. A