Hayward AQUARITE FLO ADVANCED Guide De L'utilisateur page 26

Connection
 P1/P2: Operating cell polarity. The cell changes polarity automatically to clean itself.
 Lgt: Lighting is on.
 Cov: Cover detector indicates that it is closed. Production will reduce automatically to the value configured in the
electrolysis menu.
 FL: Lack of water flow in the installation. Monitor the flow switches and check that the pressure is correct.
 Low: Production of the device is not reaching the desired level. This can be due to various factors:
- Lack of salt,
- Scaled-up cell,
- Exhausted cell (check the hours counter),
- Low water temperature.
 AL3: Maximum time exceeded for acid dosing. Check pH readings, calibration and verify that the acid reservoir is not
empty. To reset the alarm press the 'Back' key.
Page 12 of 12
13. VARIABLE SPEED PUMP
VARIABLE SPEED
PUMP

Slow

Medium

Fast

Common
13.1 Variable Speed Pump: to install
a variable speed pump contact your
installer.
14. DESCRIPTION OF NOTICES
USE ONLY GENUINE REPLACEMENT PARTS
AquaRite Flo Advanced
13.1
13.2 – 13.4 Once the pump has been connected, you can assign a different speed
individually to each filtration period
13.4
13.5 Filter cleaning: to clean a filter
with a variable speed pump, you
should use the 'fast' speed setting.
13.2
S: slow, M: medium and F: fast.
13.5
13.3
Rev. A