Kenwood FDM30 Instructions page 14

18 19
/ Mini Chopper/Mill
a
Jar
b
Sealing ring
c
Blade assembly
1 Put the ingredients into the jar.
2 Fit the sealing ring into the blade assembly.
3 Turn the blade assembly upside down. Lower
it into the jar, blades down.
4 Screw the blade assembly onto the jar until
finger tight. Refer to the graphics on the
underside of the blade assembly as follows:
- Unlocked position
- Locked position
5 Place the mill onto the power unit, align
the on the mill with the
unit and turn clockwise to lock.
6 Select Maximum speed or use the pulse (P).
Hints and Tips
Baby food/purée - allow cooked food to
cool down to room temperature before
processing in the mill.
For best results the main bowl is
recommended when chopping herbs.
20
Grinding Mill
a
Mill lid
b
Grinding mill blade assembly
1 Place your ingredients into the blade
assembly.
2 Fit the lid and turn clockwise to lock.
3 Place the mill onto the power unit and turn
clockwise to lock.
4 Select maximum speed or use the pulse (P).
Hints and Tips
For optimum performance when processing
spices do not process more than 50g at a
time.
Whole spices retain their flavour for a much
longer time than ground spices so it is best
to grind a small quantity fresh at a time to
retain the flavour.
To release the maximum flavour and
essential oils whole spices are best roasted
prior to milling.
Do not process dried turmeric root in the mill
as it is too hard and may damage the blades.
Cut ginger and coconut into small pieces
before processing.
For best results the main bowl is
recommended when chopping herbs.
(if supplied)
on the power
(if supplied)
21
Juice Extractor
a
Pusher
b
Juicer lid
c
Pulp remover
d
Filter drum
e
Bowl
f
Juicing spout
To use the juice extractor
1 Fit the juicer bowl to the power unit, turn
clockwise until it locks - the spout should
be situated to the left side when the bowl is
fitted correctly.
2 Place the pulp remover into the filter drum -
ensuring the tabs locate with the slots in the
bottom of the drum.
3 Fit the filter drum
4 Fit the attachment lid - turn clockwise until
it locks. Your juicer will not operate if the
bowl or lid are not fitted correctly into the
interlock .
5 Place a suitable glass or jug under the juice
outlet.
6 Cut the food to fit the feed tube.
7 Switch on and push down evenly with the
pusher - never put your fingers in the feed
tube. Process fully before adding more.
After adding the last piece, let the juicer run
for a further 30 seconds to extract all the
juice from the filter drum.
important
If the juicer starts to vibrate, switch off and
empty the pulp from the drum. The juicer
vibrates if the pulp becomes unevenly
distributed.
Some very hard foods may make your juicer
slow down or stop. If this happens switch off
and unblock the filter.
Switch off and clear the pulp collector
regularly during use.
Hints and Tips
Before processing remove stones and pips
(eg pepper, melon, plum) and tough skins
(e.g. melon, pineapple). You do not need to
peel or core apples and pears.
Use firm, fresh fruit and vegetables.
8
(if supplied)