Kenwood FDM30 Instructions page 12

To Use Your Food Processor
Illustrations –
1 Fit the detachable drive shaft onto the power
unit.
2 Then fit the bowl by aligning the
bowl with the on the power unit, turn
clockwise until it locks
3 Fit an attachment over the bowl drive shaft.
Always fit the bowl and attachment onto the
processor before adding ingredients.
4 Fit the lid - ensuring the top of the drive
shaft/tool locates into the centre of the lid.
Do not use the lid to operate the processor,
always use the on/off speed control.
5 Plug in, switch on and select a speed. (Refer
to the recommended usage chart).
The processor will not operate if the bowl
or lid are not fitted correctly into the
interlock. Check that the feed tube and
bowl handle are situated to the right front
hand corner.
Use the pulse (P) for short bursts. The pulse
will operate for as long as the control is held
in position.
6 Reverse the above procedure to remove the
lid, attachments and bowl.
Always switch off and unplug before
removing the lid.
Important
Your processor is not suitable for crushing
or grinding coffee beans, or converting
granulated sugar to caster sugar.
When adding almond essence or flavouring
to mixtures avoid contact with the plastic as
this may result in permanent marking.
Using The Attachments
Refer to recommended usage chart
for each attachment.
10A
Plastic Blender
To Use Your Blender
Illustrations –
1 Fit the sealing ring into the blade
assembly - ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal is damaged or
incorrectly fitted.
2 Hold the underside of the blade assembly
and insert the blades into the goblet - turn
anti-clockwise until it is secure. Refer to
the graphics on the underside of the blade
assembly as follows:
- Unlocked position
- Locked position
on the
.
(if supplied)
3 Put your ingredients into the goblet.
4 Fit the lid onto the goblet and turn clockwise
until it clicks. Fit the filler cap.
5 Place the blender onto the power unit, align
the on the blender with the
power unit and turn clockwise to lock
The appliance will not operate if the blender
is incorrectly fitted to the interlock.
10B
Glass Blender
To Use Your Blender
Illustrations
1 Fit the sealing ring into the blade unit -
ensuring the seal is located correctly in the
grooved area.
Leaking will occur if the seal is damaged or
incorrectly fitted.
2 Screw the goblet onto the blade assembly.
Refer to the graphics on the underside of the
blade unit as follows:
- Unlocked position
- Locked position
3 Put your ingredients into the goblet.
4 Fit the lid to the goblet and push down to
secure. Fit the filler cap.
5 Place the blender onto the power unit, align
the on the blender with the
power unit and turn clockwise to lock.
The appliance will not operate if the blender
is incorrectly fitted to the interlock.
Hints and Tips
When making mayonnaise, put all the
ingredients, except the oil, into the blender.
Remove the filler cap. Then, with the
appliance running, add the oil slowly through
the hole in the lid.
Thick mixtures, e.g. pâtés and dips, may need
scraping down. If the mixture is difficult to
process, add more liquid.
The processing of spices is not
recommended as they may damage the
plastic parts.
To blend dry ingredients - cut into pieces,
remove the filler cap, then with the appliance
running, drop the pieces down one by one.
Keep your hand over the opening. For best
results empty regularly.
6
on the
(if supplied)
–
on the
.