SOUNDMASTER UR8200 Mode D'emploi page 20

Turning the alarms on or off in standby mode
1. In standby mode, press the ALARM button once to show "ALARM CH" on the display. Then
press the "ALARM" button (7) repeatedly to cycle through the alarm on or off settings. See
the table below for details.
Pressing ALARM
1×
2×
3×
4×
2. Press the „SELECT" button (6) to confirm the setting.
When the alarm setting is active, the corresponding alarm 1 or alarm 2 icon will show on the
display.
Deactivating a sounding alarm
Press the „POWER" button (13) or "ALARM" button (7) "to switch the radio to standby mode.
Snooze
• To temporarily silence a sounding alarm, press the „SNOOZE" button (12). To change the
snooze period, press the „SNOOZE" button (12) repeatedly (options: 5, 10, 15 or 30
minutes). The corresponding alarm icon flashes during the snooze period.
• The radio will return to standby mode during the snooze period. The alarm will sound again
when the snooze period is over.
• To cancel the snooze period and the alarm, press the „POWER" button (13).
Sleep
This sleep function defines the duration of time before the radio switches itself off automatically.
1. When the radio is switched on, press the „SLEEP" button (12) repeatedly to select a sleep
period (Options: Off, 15, 30, 45, 60 and 90 minutes).
2. Press the „SELECT" button (6) to confirm the selection.
Once a sleep period is set, the sleep mode icon will show on the display. The radio will
automatically switch off when the sleep period is over.
To cancel the sleep function, press the „POWER" button (13).
• Press the "PROJECTOR ON/OFF" button (4) to project the current clock time on a wall.
• Lift the projector up to adjust the angle of projection.
• Press the "180° FLIP" button(5) to flip the projected image.
• Turn the FOCUS dial (21) to adjust the image sharpness.
Alarm 1 Alarm 2
On
Off
On
Off
PROJECTOR
7
UR8200 / English Instruction Manual
Off
On
On
Off