Tools Required; Fitting Instructions - R&G CP0355BL Instructions De Montage

2
1
Page | 2
6
LEGEND
ITEM 1 = BC0002 CRASH PROTECTOR CAPS (x2).
ITEM 2 = B0061 with CS341 (10mm) (CRASH PROTECTORS) (x2).
ITEM 3 = S0366 SPACERS (x2).
ITEM 4 = M10x1.25x120mm LONG HEX HEAD BOLT (x2).
ITEM 5 = M10 PLAIN WASHERS (x2).
ITEM 6 = LW0001 ( SHAKE PROOF WASHERS) (x2).

FITTING INSTRUCTIONS

Left Side (as you sit on bike)

Remove the engine bolt on the left side of the bike, as arrowed in picture A.

Slide one of the 10mm washers (item 6) onto the M10x120mm long hexagon headed bolt
(item 4) so the washer sits against head of bolt.

Slide serrated locking washer (item 5) over the bolt so it sits against washer just fitted.

Next slide the bolt with washers through either crash protector (item 2) so head of bolt and
washers goes into counter-bore in bobbin.

Slide one of the spacers (item 3 over the exposed end of the bolt with the larger diameter
against the crash protector.

Offer the crash protector and spacer assembly up to the frame mount and begin to tighten the
bolt as shown in picture A.

Tighten the bolt until you feel some compression from inside the protector using 17mm socket
and wrench. PLEASE NOTE THE CRASH PROTECTOR MUST BE POSITIONED AS
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
5
LEFT

TOOLS REQUIRED


Socket set to include 17mm socket and wrench.

Socket set to include 8mm A/F socket and wrench.

Torque wrench (up to 40 Nm).
3
3
4
4
R&G Racing
www.rg-racing.com Email:
2
5
RIGHT
info@rg-racing.com
1
6