Facing In; Securing Your Child; Head Support - Nuna cudl clik Mode D'emploi

Facing In

Infant Booster
8–15 lb (3.5–7 kg)
Birth - 4 months

Securing Your Child

We recommend sitting down while securing your child in the carrier, as it
provides better control.
1
- Begin with the carrier fully open (and the infant booster secured if your child
weighs less than 15 lb [7 kg]). (17)
2
- Attach one side buckle where you see the
3
- Hold your child securely against your chest with one hand, and use the
other to raise the front of the carrier. (19)
4
- Guide your child's leg down and through the opening between the seat/
booster and the attached side buckle. (20)
5
- Use one hand to hold the carrier and your child against you, and use the
other to secure the other side buckle where you see the
6
- Holding your child in the carrier with one hand, secure the shoulder buckles
one at a time where you see the
7
- Gently pull both shoulder buckle adjustments down to adjust the fit. (23)
13 CUDL™ clik instructions
15–30 lb (7–13.5 kg)
4+ months
OR
green indicator. (18)
green indicator. (21)
green indicators. (22)
8
- Adjust the shoulder straps by gently pulling both shoulder adjustment
straps evenly out in front of you. (24)
9
- Make sure your child is comfortable and securely seated in the baby carrier.
Adjust the straps around your child and check to make sure all buckles and
snaps are secure. Allow room for your child's head movements and keep
child's face free from obstructions. (25)
Your child should be positioned close to you, high on your body.
Keep your child's face visible to you at all times.

Head Support

1
- For a child weighing 8–15 lb (3.5–7 kg), secure the head support so that it is
up and supporting the child's head and neck area. Attach the head support
to the upper head support buttons. Only fold the head support down when
the child is able to hold his or her head up (approx. 4 months). (26)
2
- To fold down, slide both upper head support buttons out of the button holes
on the head support. (27)
3
- Fold the head support down. (28)
4
- Attach both bottom head support buttons into the button holes on the head
support. (29)
5
- Make sure your child is comfortable and securely seated in the baby carrier.
Adjust the straps around your child and check to make sure all buckles and
snaps are secure. Allow room for your child's head movements and keep
child's face free from obstructions. (30)
6
- To remove the head support, unzip it from the carrier. (31)
CUDL™ clik instructions 14