Table des Matières
Publicité
9
- Pull down on the shoulder adjustment straps to tighten. Adjust the yoke up
or down vertically and side to side. (43)
10
- Roll up the excess length of the shoulder adjustment straps and use the
elastic loop to wrap around the rolled up strap to store it out of the way. (44)
11
- Make sure your child is comfortable and securely seated in the baby carrier.
Adjust the straps around your child and check to make sure all buckles and
snaps are secure. Allow room for your child's head movements and keep
child's face free from obstructions. (45)
Accessories
Bib
1
- Make sure the head support is folded down and secured in place with the
lower head support buttons. (46)
2
- Store the extra length of the shoulder buckle adjustment in the pocket on
the shoulder buckle strap. (47)
3
- Cover the front of the head support with the front of the bib and slide both
head support buttons through the button holes on the bib. (48)
4
- Fold and tuck the bib over the top edge of the head support. (49)
5
- Wrap both side edges of the bib around the shoulder buckle strap. The
back edge of the bib is slid between the shoulder strap and shoulder buckle
strap. The front edge of the bib is laid over the shoulder buckle strap. (50)
6
- Attach the sides of the hook and loop. Make sure the bib is laying flat and is
secure to the top edge of baby carrier. (51)
Harness Covers
1
- Unbutton the head support and fold it down. (52)
2
- Store the extra length of the shoulder buckle adjustment in the pocket on
the shoulder buckle strap. (53)
3
- Slide the harness cover between the shoulder strap and the shoulder buckle
strap. (54)
4
- Slide the button on the shoulder buckle strap through the button hole on the
harness cover. (55)
5
- Attach the hook and loop. Make sure the bottom edge of the harness cover
is tucked behind the head support. (56)
6
- Repeat on the other side. When both harness covers are secure, attach both
bottom head support buttons into the button holes on the head support.
(57)
17
CUDL™ clik instructions
Hood
1
- Make sure the head support is up and secured in place with the upper head
support buttons. Undo the snap on the pocket located on the top edge of
the head support. (58)
2
- Pull the hood out of the hood pocket. (59)
3
- Adjust the hood to the desired position to shade your child. (60)
4
- Attach three snaps on the hood strap to the three snaps on the shoulder
strap. Repeat for the other side. (61)
Make sure the hood is not covering your child's mouth or laying too tightly
over their head.
Breeze Cover
1
- Unroll breeze cover from pocket at the bottom of the carrier when needed.
(62)
2
- Attach breeze cover by fastening to head support button. (63)
Storage Pocket
Storage Pocket can be tied to waist band or used separately. (64)
Storage Bag
CUDL
clik can be stored in storage bag. (65)
™
Cleaning and Maintenance
Refer to the care label attached to the carrier fabric for washing and drying
instructions. Carrier MUST be washed inside a mesh laundry bag.
It is normal for fabric to fade from sunlight and to show wear and tear after a
long period of use, even when used normally.
For safety reasons, only use original Nuna parts.
Check regularly that everything functions properly. If any parts are torn, broken,
or missing, stop using this product.
NUNA International B.V. Nuna and all associated logos are trademarks.
CUDL™ clik instructions
18
Publicité
Table des Matières
