Battery Packs; Operating Procedure - Stanley ProSet PB3400 Traduction Des Instructions Originales

E N G L I S H
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold, it automatically starts a hot/cold pack
delay, suspending charging until the battery has reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This feature ensures maximum battery life. A cold battery
pack will charge at about half the rate of a warm battery pack. The battery pack will charge at that slower rate
throughout the entire charging cycle and will not return to maximum charge rate even if the battery warms.
Lithium-Ion Battery Packs
STANLEY Engineered Fastening PB Series Li-Ion tools are designed with an Electronic Protection System that
will protect the battery against overloading, overheating or deep discharge. The tool will automatically turn
off if the Electronic Protection System engages. If this occurs, place the Li-Ion battery on the charger until it is
fully charged.

4.3 BATTERY PACKS

Your tool is designed to work specifi cally with DEWALT®/POP® Avdel® 18V/20V max Li-Ion battery packs.
Inserting and Removing the Battery Pack from the Tool (fi g. 3)
NOTE: For best results, make sure your battery pack is fully charged. The tool will shut off without warning when the
battery is fully discharged.
TO INSTALL THE BATTERY PACK INTO THE HANDLE

Align the battery pack (K) with the rails inside the tool's handle (fi g. 3).

Slide it into the handle until the battery pack is fi rmly seated in the tool and ensure that it does not
disengage.
TO REMOVE THE BATTERY PACK FROM TO THE HANDLE

Press battery release button and fi rmly pull the battery pack out of the tool handle.

Insert battery pack into the charger as described in the charger section for this manual.
Storage Recommendations

The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. For
optimum battery performance and life, store battery packs at room temperature when not in use.

For long storage, it is recommended to store a fully charged battery pack in a cool, dry place out of the
charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be
recharged before use.

5. OPERATING PROCEDURE

WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a
sudden reaction.
15