R&G LP0111BK Instructions De Montage page 3


FIT NEW LICENCE PLATE ILLUMINATOR (ITEM 7) TO NEW LICENCE PLATE
BRACKET (ITEM 1) AS SHOWN IN PICTURE 3, HEAT SHRINK IS SUPPLIED TO
PROTECT THE WIRES (ITEM 2) .

PLEASE NOTE YOU WILL NEED TO GLUE THE LIGHT SHROUD TO THE LED
LICENCE PLATE ILLUMINATOR BEFORE FITTING USING SUPER GLUE.

FIT NEW LICENCE PLATE ILLUMINATOR TO THE LICENCE PLATE BRACKET (AS
Page | 3
SHOWN IN TOP PICTURE). TO CONNECT THE NEW LICENCE PLATE
ILLUMINATOR WE SUGGEST CUTTING AND REUSING THE ORIGINAL PLUG
SOCKET, PLEASE USE HEAT SHRINK PROVIDED TO PROTECT WIRING. WHEN
REMOVING THE ORIGINAL PLUG SOCKET PLEASE REMOVE THE ORIGINAL
HEAT RESISTANT TUBE FROM WIRING AND FIT OVER THE NEW HEAT SHRINK
BEFORE FITTING BULLET CONNECTORS FROM ITEM 7.

REMOVE THE CABLE COVER FROM THE ORIGINAL LICENCE PLATE BRACKET
AND REMOVE ORIGINAL INDICATORS AND FIT TO NEW LICENCE PLATE
BRACKET USING THE ORIGINAL BOLTS AND THE M8 WASHERS FROM KIT AS
SHOWN IN PICTURE 3 (THE WASHERS ACT AS SPACERS).

IF FITTING R&G MINI'S (PRODUCT CODE RG370) RESISTORS MAY BE REQUIRED
(PRODUCT CODE RGR0001).

FEED THE LICENCE PLATE ILLUMINATOR AND INDICATOR WIRES THROUGH
THE HOLE IN THE LICENCE PLATE BRACKET (SEE PICTURE 4) AND SECURE
USING THE CABLE TIE FROM KIT.

FEED THE WIRES THOUGH HOLE IN EXHAUST AND ROUTE AS ORIGINAL AND
RECONNECT WIRING SOCKETS. IT IS A GOOD IDEA TO TEST ALL LIGHTS AT
THIS STAGE.

USING THE ORIGINAL HEAT RESISTANT WASHERS BETWEEN THE LICENCE
PLATE BRACKET AND THE LICENCE PLATE MOUNTING SPIGOTS, SECURE THE
BRACKET AS ORIGINAL USING THE LONGER BUTTON HEAD BOLT AND ONE M8
WASHER IN POSITION MARKED 'B', USING THE TWO SHORTER BUTTON HEAD
BOLTS AND THE REMAINING M8 WASHERS SECURE THE BRACKET IN
POSITIONS MARKED 'A' IN PICTURE 4 (THE WASHERS ACT AS SPACERS).

REFIT THE ORIGINAL CABLE TIDY/COVER.

REFIT PILLION SEAT.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
3
PICTURE
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
B
A
R&G Racing
www.rg-racing.com Email:
3
4
PICTURE
info@rg-racing.com
A