Migatronic FOCUS TIG 200 PFC Guide Rapide page 4

11
4
5
2
10 12
18
15 16 17
13 14 9 7 8
1. Welding current/Arc voltage
Press the key and turn the control knob
to set the welding current.
Press the key for 3 seconds to display
the arc voltage (valid ONLY for TIG
DC and MMA DC). Press again "A" to
display the welding current.
2. Welding voltage
The LED shines when there is voltage
on MMA electrode or TIG torch.
3. Parameter units
The LED shines when the relevant
parameter unit is active.
4. Overheating indicator
The LED shines when the machine is
overheated.
5. Mains error
The LED shines if the mains voltage is
too high or too low.
6. Welding process
Choice of MMA/TIG.
3
7. Trigger mode
Choice of 2-stroke/4-stroke.
1
8. Current adjustment
Choice of torch adjustment.
9. Ignition method
Choice of HF/LIFTIG ignition.
®
6
10. Gas pre flow (time)
11. Slope down
Time from welding current to stop
amp.
12. Gas post flow (time)
13. Pulse
Key activated = pulse.
14. Pulse setting
Press the menu key until the LED shines
at:
• Pulse time: Welding current period.
• Pause time: Base current period.
• Base current: % of pulse current.
15. Current type
Choice of AC or DC welding.
16. AC-t-balance, time-based
Time balance between positive and
negative half-wave is adjusted in %.
17. AC-electrode preheating
Automatic electrode preheating.
18. Choice of secondary parameters
Opens parameters 10, 11 and 12.
QUICKGUIDE
FOCUS TIG 200
PFC