Elcometer 415 Guide D'utilisation page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
15 APPENDIX 2: ELCOMASTER COLLECT DESIGN (continued)
To use a 'Collect Design':
1
Click on the 'View' tab and select a
folder or project.
2
Click on 'New''Batch Item''Dry
Film Thickness' and select the
required Collect Design. A new
batch will be created. Unlike
standard batches it will have an
additional tab with the same name
as the Collect Design, click on this
to show your design.
3
To begin collection, click on
'Connect Gauge' in the 'Live
Readings' window.
4
Select a gauge from the list .
5
Select the relevant connection
method.
®
ElcoMaster will link the selected
gauge and, when ready, display the
gauge information within the Live
Readings window.
Once connected, green arrows will
flash around the first 'reading' circle to
measure. When a measurement is
taken, the 'reading' circle will change to
show the measured value , and the
green arrows will move to the next
reading.
The gauge must be connected to ElcoMaster before it will appear in the list.
The 'reading circle' will be green if the measurement is within set limits or no limits have been set and red,
if outside set limits.
www.elcometer.com
®
®
R
en-14

Publicité

Table des Matières
loading

Table des Matières