Beurer BM 49 Mode D'emploi page 69

Now insert the cuff line into the connection for
the cuff connector.
This cuff is suitable for you if the index mark
( ▼) is within the OK range after fitting the cuff
on the upper arm.
If the measurement is performed on the right upper arm, the line
should be located on the inside of your elbow. Ensure that your arm
is not pressing on the line.
Blood pressure may vary between the right and left arm, which may
mean that the measured blood pressure values are different. Always per-
form the measurement on the same arm.
If the values between the two arms are significantly different, please con-
sult your doctor to determine which arm should be used for the meas-
urement.
Caution: The unit may only be operated with the original cuff. The cuff is
suitable for an arm circumference of 22 to 36 cm.
A larger cuff for upper-arm circumferences of 35 to 44 cm can be ob-
tained from specialist retailers or from the service address using order
number 163.387.
Adopt the correct posture
• Rest for approx. 5 minutes before each measure-
ment. Otherwise there may be divergences.
• You can perform the measurement either sitting or
lying down. Always make sure that the cuff is on a
level with your heart.
• To carry out a blood pressure measurement, make
sure you are sitting comfortably with your arms and
back leaning on something. Do not cross your legs.
Place your feet flat on the ground.
• In order not to distort the result, it is important to
keep still during the measurement and not talk.
Selecting memory
• Switch on the device with the
Start/stop button.
When the device is switched
off, the time and date are per-
manently displayed.
• Select the desired user memory by
pressing the function buttons
69
Voice output when voice function
is active
The device is ready for use.
You may start measuring.
.
User memory 1
User memory 2