Turning On The Glasstron; Checking The Display Unit Position - Sony Glasstron PLM-A55E Mode D'emploi

Turning on the Glasstron

After you complete all of the connections and put on the Glasstron properly, turn on the
Glasstron and follow the procedures below.
1 Checking the display unit position n This page
2 Checking the screen position alignment n Pages 19 through 21
3 Setting a password n Pages 22 and 23
If you do not want to use a password, you have to set the Glasstron to operate without
using a password in "Setting the password."

Checking the display unit position

Every time you turn on the Glasstron, the adjustment screen appears to help you adjust the
display unit properly. Adjust the display unit following the procedure below.
1
Turn on the Glasstron using the POWER switch.
The POWER lamp lights up.
2
Turn the SEL/PUSH EXEC jog dial to select the desired language,
then press the jog dial.
3
Read the WARNING and press the jog dial.
POWER
ON / OFF
PUSH DISPLAY
SEL / PUSH EXEC
PUSH DISPLAY
SEL / PUSH EXEC
Screen
DISPLAY LANGUAGE
ENGLISH
FRANÇAIS
DEUTSCH
ITALIANO
NEDERLANDS
ESPAÑOL
SEL EXEC
DISPLAY LANGUAGE
ENGLISH
FRANÇAIS
DEUTSCH
ITALIANO
NEDERLANDS
ESPAÑOL
SEL EXEC
WARNING
FOR YOUR SAFETY AND TO
PREVENT EYE OR OTHER
INJURY, READ AND FOLLOW
ALL INSTRUCTIONS IN THE
USER'S MANUAL.
CHECK
continued
17
-GB