Adjusting The Brightness Of Photos - Lexmark P350 Mise En Route

14
Press or
Note: Pressing
Pressing when the image is not selected will select the image.
15
You can select more photos for printing and editing by repeating step 6 through step 14.
16
Press to go to the Print Preview screen.
17
If you want to adjust the print settings:
a
Press .
b
Make your selections.
c
Press to save your selections, and then go back to the Print Preview screen.
18
Press to print.
Note: To prevent smudging or scratching, avoid touching the printed surface with your
fingers or sharp objects. For best results, remove each printed sheet individually from the
paper exit tray, and allow the prints to dry at least 24 hours before stacking, displaying,
or storing.

Adjusting the brightness of photos

1
Load photo paper with the glossy or printable side facing you. (If you are not sure which
side is the printable side, see the instructions that came with the paper.) For more
information, see "Loading paper" on page 20.
2
Insert a memory card or flash drive. For more information, see "Inserting a memory card"
on page 21 or "Inserting a flash drive" on page 23.
3
Press or repeatedly until View and Select appears on the display.
4
Press .
5
Press to continue.
6
Press or to navigate through the photos.
7
Press to select a photo for printing.
8
Press .
The Photo Edit Mode menu appears.
9
Press or
10
Press or to adjust the brightness of the photo.
Note: The image on the display does not accurately reflect the image when printed.
to select the number of copies to print.
when the number of copies is set to 1 will deselect the image.
repeatedly until Brightness appears on the display.
34